 | 2 H.P. PORTABLE ELECTRIC AIR COMPRESSOR-6CFM | | This 115 volt compressor is the perfect companion for the Forward and Reverse Air Whisk since it plugs into a standard 15 amp electrical outlet. Provides 125 P.S.I. at 6 CFM. It does not provide sufficient pressure or flow for the Sidewinder, but will work well for cleaning coils, blowers etc. using the power air nozzle, air trigger nozzle and will provide air for the Cobra brush system. Item #CE1588 | |  | 8 H.P. PORTABLE AIR COMPRESSOR | | If you require the smallest, lightest package that will deliver 175 P.S.I. two-stage performance at 14 CFM for the Sidewinder, Air Trigger Nozzle, Power Air Nozzle and Air Whisk, this 8 HP GASOLINE POWERED air compressor is ideal. The recoil start, 8 HP gasoline engine is mounted on stable maneuverable one-wheel frame that fits easily in a standard size van with the negative air machines. Item #CE1559 | |  | 12.5 H.P. TRUCK MOUNTED AIR COMPRESSOR | | This ruggedly built 25.1 CFM TWO STAGE COMPRESSOR will provide a sufficient supply of 175 P.S.I. air to obtain the highest level of performance from all Air-Care Equipment requiring compressed air, including the Sidewinder Duct Cleaner. The 12.5 H.P. gasoline engine is a standard in the industry. This truck mounted package is equipped with a 12 volt starter and charging system that can be connected to the vehicles electrical system or fitted with its own 12 volt battery (battery & cables not included). Item #CE1537 | | |  | AIR TRIGGER NOZZLE | | For general cleaning with compressed air when outside, or in an area being evacuated and filtered by the Turbojet, this hand held air gun will provide an economical device for cleaning blowers, coils or your duct cleaning equipment to keep it looking and performing at its peak efficiency. Item #CE1508 |  | POWER AIR NOZZLE | | For those hard to reach places, such as the back-side of heat exchangers, coils, and blower wheels. This pistol grip and 30” copper extension can be bent to direct the air where you need it. Special venturi tip increases thrust by 200%. This is one of those tools you can’t do without. Item #CE1125. |  | HOLECUTTERS | To properly clean some duct systems it may be necessary to “cut-in” to attach a negative air machine or to access
areas for contact vacuuming. Air-Care offers 3 hole cutters that will work in 18 gauge or lighter steel.
1. The Drill-powered shear will cut straight or slight curves, as well as making 90 degree corners. It requires a half inch pilot hole to get started and is easily attached to your cordless or electric drill (not included). Item #CE1432
2. The adjustable circular hole cutter is the easiest to use. It requires a cordless or electric drill (not included), and will drill its own 1/8 inch center hole. The sliding/locking center pivot pin has a built in scale to cut precise holes from 2 to 12 inches in diameter. Item #CE1503
3. The Air Powered Nibbler tool will cut straight, round or any irregular shape, but it requires a 1⁄2 inch pilot hole to get started. It comes with a QD 21 male air fitting and runs on 90 psi @ 20 CFM. Item #CE3041 | |
